BH-10/20瀝青混合料拌和機

瀝青混合料拌和機產品簡介：

該儀器是制備瀝青砂石混合料或水泥砂石混合料試樣時拌和機械。本儀器嚴格按照J(rèn)TJ052—2000《公路工程瀝青及瀝青混合料試驗規程》的各項規定設計生產。目前它已被廣泛地應用于公路系統的科研、施工和監理部門的實驗室中。

Product Introduction of Asphalt Mixer:

The instrument is a mixing machine for preparing samples of asphalt sａnd and gravel mixture or cement sａnd and gravel mixture. This instrument is designed and manufactured in strict accordance with the provisions of the Ministry of Communications JTJ052-2000 "Testing Rules for Asphalt and Asphalt Mixtures of Highway Engineering". At present, it has been widely used in the laboratories of scientific research, construction and supervision departments of highway systems.

瀝青混合料拌和機主要特點：

自動控溫，控溫精度高（空鍋±3），自動控制拌和機頭上升下降，整機靜電噴圖，外觀新穎漂亮。一鍵式控制，儀器從放料到試驗完成可以全自動控制。

Main features of asphalt mixture mixer:

Automatic temperature control, high temperature control accuracy (empty pan ± 3), automatic control of mixing head up and down, electrostatic spraying of the whole machine, new and beautiful appearance. One-button control, the instrument can be fully controlled from discharging to test completion.

瀝青混合料拌和機技術參數:

★拌和容量：10升（20升）兩種選購

★加熱鍋溫度范圍：室溫～250℃（任意設定）

★控溫精度：±3℃

★拌和時間：1～999秒（任意設定）

★攪拌漿轉速：公轉48r/min自轉76r/min

★外形尺寸：1AX560X1270mm 1220X620X1320mm

★重量：190KG 236KG

★電源電壓：220V

★功率：3KW

★環境溫度：5～40℃

★環境濕度：≦85﹪

Technical parameters of asphalt mixer:

★ Mixing capacity: 10 liters (20 liters)

★ Temperature range of heating pot: room temperature ~ 250 ℃ (optional)

★ Temperature control accuracy: ± 3 ℃

★ Mixing time: 1 ～ 999 seconds (arbitrarily set)

★ Rotating speed of stirring pulp: revolution 48r / min and rotation 76r / min

★ Dimensions: 1AX560X1270mm 1220X620X1320mm

★ Weight: 190KG 236KG

★ Power supply voltage: 220V

★ Power: 3KW

★ Ambient temperature: 5 ～ 40 ℃

★ Ambient humidity: ≦ 85 ﹪

瀝青混合料拌和機操作和使用：

★ 接通電源、打開電源開關，電源指示燈亮。

★ 按工作需要設定加熱溫度，先按溫度表上的“SET"鍵0.5秒，PV窗顯示“SV"，SV窗位閃爍，按位移鍵“←"將閃爍位移至需設定位，按加減鍵“↑↓"直到將數字設定至所需值，按“SET"鍵確認，設定結束。

★ 時間設定，標準的攪拌時間為90秒，也可按工作需要自行設置，打開時間繼電器有機玻璃蓋板，按撥盤開關，按至所需值。

★ 設置完后，打開加熱開關，加熱鍋開始加熱，按上升鍵，攪拌器上升一定位置 后自動停止，將預熱料加熱鍋內蓋上鍋蓋：加熱至160℃時，拿去箱蓋，按下降和攪拌鍵，攪拌器開始攪拌和下降（到A低位置可自動停止），至規定的時間攪拌器自動停止，按上升鍵加入規定的礦粉，再重復上述的操作。

Asphalt Mixer Operation and Use:

★ Turn on the power, turn on the power switch, and the power indicator is on.

★ Set the heating temperature according to the work requirements. First press the "SET" key on the thermometer for 0.5 seconds. The PV window displays "SV" and the SV window blinks. Press the shift key "←" to shift the blinking to the required setting position. Press Add and subtract keys "↑ ↓" until the number is set to the desired value, press the "SET" key to confirm, the setting is completed.

★ Time setting. The standard mixing time is 90 seconds. It can also be set according to the needs of the work. Open the plexiglass cover of the time relay and press the dial switch to the required value.

★ After setting, turn on the heating switch, the heating pot starts to heat, press the up key, the stirrer will automatically stop after it rises to a certain position, and cover the inside of the preheating heating pot: when it is heated to 160 ° C, remove the lid. Press the down and stirring key, the agitator starts to stir and fall (it can stop automatically to the low position of A), the agitator will automatically stop at the specified time, press the up key to add the specified mineral powder, and repeat the above operation.

瀝青混合料拌和機常見現象及排除：

★ 瀝青混合材料攪拌機是采用加熱管加熱，二層內加熱加入導熱油后，熱傳遞到拌和鍋的各部；第三層為保溫層，再鍋口左外側有加熱管的接線端，電壓為220V，右移為感溫探頭插孔，再右移為氣壓閥門，在加熱過程中，如有少量導熱油從中溢出，或鍋邊有局部油漆鼓起的現象，都為正常的現象。

★如果機器在運輸過程中有局部損壞，特別是上下限位開關移位，如造成了下限位開關不停機，但面板操作鍵仍作用，在使用時應立即停機檢查，打開后蓋板換上同規格的開關即可。

Common Phenomenon of Asphalt Mixer and Elimination:

★ Asphalt mixed material mixer is heated by heating tube. After adding heat transfer oil in the second layer, the heat is transferred to each part of the mixing pot; the third layer is the insulation layer, and there is a heating tube terminal on the left and outer side of the pot. The voltage is 220V To the right is the temperature sensor jack, and then to the right is the air pressure valve. During the heating process, if there is a small amount of thermal oil overflowing from it, or there is a phenomenon of local paint bulging near the pot, it is normal.

★ If the machine is partially damaged during transportation, especially the upper and lower limit switches are shifted, if the lower limit switch does not stop, but the panel operation keys still work, stop the machine immediately when using it, and open the rear cover and replace it. A switch of the same specification is sufficient.

瀝青混合料拌和機結構：

瀝青混合材料攪拌機主要由機架、變速攪拌器（由電機、變速箱和攪拌葉組成）、升降機構（主要由一臺電機、蝸輪箱、立柱和導向桿及限位裝置組成）、加熱鍋總成（由雙層金屬鍋、導熱油、電熱管組成）、電器控制部分等組成。

Asphalt Mixer Structure:

The asphalt mixing material mixer is mainly composed of a rack, a variable speed mixer (consisting of a motor, a gearbox, and stirring blades), a lifting mechanism (mainly consisting of a motor, a worm gear box, a column and a guide rod, and a limiting device), and a heating pot (Composed of double-layer metal pot, heat-conducting oil, electric heating tube), electrical control part, etc.